板塀一発　フェンスの自作ならお任せ！ 1.10 Apk

- How to use ~

[Input data]
Enter the width of the total length of the fence and the plate at the beginning. (All of the input unit is "mm") Other, and then calculated automatically when you input interval of the plate and the plate, pitch, and any of the number of sheets. In addition to re-calculation every time you want to update the numbers.
But appears remains would dimension without divisible in the upper right corner of the ※ screen, in the "List Mode" that lists the marking position to the Birds Nest, or allocated to the whole, so choose either forgive the wings out of the Birds Nest, It is okay to not have to force the "0".

[Birds Nest and the hole position]
• When you enter the Birds Nest dimension demon, is calculated automatically size of the switching things to display. To cut or things to the right edge or the left edge of the fence, can be set in the next "List Mode".
Takasho etc. ※, Birds Nest 4 mm If you indulge in the joint parts I'm four meters, enter 4004 instead of 4000.
- The position of the prepared hole for fixing the Birds Nest plate and enter the distance from the edge of the plate. Enter only one side even if you are fixed with two screws to the Birds Nest.

[List mode]
Once you have entered all the required data, it will move to List mode when you tap the "List" button.
• The marking position to be displayed in the list I can choose from in the "hole position" and "Itaushiro".
• You can choose how to handle was not divisible by "input" screen "the rest".
"Distributed before" is, some photos of before the whole becomes widely only 1 mm. (Default)
"Distributed behind" it is, what pieces of behind the whole becomes widely only 1 mm.
"Leave back and forth", you can forgive the wings out of the Birds Nest without distributing the remainder to the left or right.
"Leave before", "leave behind" The same is true.
• If there is a switching mono Birds Nest, you can choose to either use the Birds Nest to do "last" use to "top".
To return to the input screen of numbers when you tap the "input" button.

The About numerical value to enter]
Caution! All numbers each unit, including a full-length and enter in the "Miri".

About permissions]
• This app is made by the Android application development software "MIT App Inventor2".
Limited by the Android OS selection of App Inventor2 (version selection) is not possible.
For this reason a lot of unnecessary permission will be required, but the intention, such as drawing out the personal information does not have any.
As soon as they are improved specification of the development software, it is unnecessary permissions are scheduled to be removed, because during the time being will remain status quo, thank you for your understanding.